Mr. Jim Erickson, 1676 Fritz Cove Road, Juneau, AK 99801, states that the project purpose is to “replace an old and deteriorated private moorage facility with a safe, more accessible and secure dock for the resident owner”. Work being proposed includes: 1. Remove from below MHW an existing 10 foot wide by 36 foot long timber approach, 30 foot long aluminum gangway, 135 linear feet of sectional hinged beach floats, and a 10 foot wide by 40 foot wide mooring float and six timber piles. 2. Install below MHW a 107 foot long (over two spans of 67 feet and 40 feet in length) elevated aluminum truss approach structure on two bents, each bent supported by two 10.75-inch diameter steel piles with a total of four steel support piles with minimum of 15 feet of embedment; 3. Install below MHW one new 20 foot wide by 60 foot long timber decked, pile-supported (two each 24-inch diameter) float on poly pipe pontoons connected to a six foot wide by 60 foot long steel gangway. The float would be outfitted with domestic water and shore power. Piles would be driven to depth with a vibratory hammer; 4. Place 0.58 cubic yards of concrete and 0.29 cubic yards of clean rock armor rock side slope fill material into 52.2 square feet below the HTL to construct a 4.5 feet wide by 10 feet long retaining wall bulkhead; All work would be performed in accordance with the enclosed plan (sheets 1-2), dated 7-20-2018. The project site is located within Section 35, T. 40 S., R. 65 E., Copper River Meridian; USGS Quad Map Juneau B-2; Latitude 58.356436º N., Longitude 134.646890º W.; USS 1547, TR 1A; 1676 Fritz Cove Road; in Juneau, Alaska. Please contact Randal Vigil at (907) 790-4491, or by email at Randal.P.Vigil@usace.army.mil if further information is desired concerning this notice.
POA-2018-00276, Auke Bay_PN and Plans